• Line-boring
• Milling, Groove Milling
• Flange facing
• Surface milling
• Boring
• Back Facing, Counterboring

We can provide you with extremely fast and qualified service, that we are expert in:

• - Crane pedestal machining
• - Shaft line machining
• - A-Frame foundation machining
• - Thruster flange machining
• - Shim plates machining
• - Torque bolting and tightening

We have available wide range of our own machinery for:

• CNC Circular Milling and facing (up to diameter of 14.000 mm with one setup)(Climax)
• Line Boring (Climax, shaft line machining, line boring of hinges, etc in diameter range 30-1100mm
• Facing and grooving (Mirage, Climax, in range 100-4000mm)
• Planar milling in range 2500 x 5500mm with one setup (Mirage, GANTRY kit)
• Shaft turning (up to 800mm outside diameter, Climax)
• Drilling and tapping (up to 100mm, M52)

Technical data:

• Measuring accuracy 0,022mm on short range up to 2 meters and 0,049 on long range up to 35 meters
• Max range - 80 meters
• Operating temperature: -15 + 50C

3D measurement is usually used for:

• Alignment of the machine to the workpiece
• Support on Fit-up on large fabrications
• Dimensional inspection after machining or welding
• Geometry check as 3d party control
• Custom applications for precise measuring data requirements, etc.

• Mechanical assembly of lifting equipment, subsea equipment, parts and units for machinebuilding, offshore and marine systems
• Electric assembly of power supply systems, motors for hydraulic systems and cable management
• Hydraulic assembly of pumps, cylinders, jacks, high pressure hydraulic hose & fitting assemblies
• Load test, pressure test, leakage test, circuit test, calibration & certification
• Torque Bolting and measurement of bolt elongation (ENERPAC)